Mon-Fri: 7AM-7PM, Sat: 8AM-5PM Licensed & Insured [email protected] Serving Hurst, TX

Gum Removal for Pavers in Hurst, TX

Pressure wash with a surface cleaner for pavers. Removing chewing gum from sidewalks, entrances and plazas with hot water and steam. Typical cost $200-$1,000.

The secret to gum removal for pavers is using the right method, not the most pressure. In Hurst, TX, we match the cleaner and pressure to the surface so it comes out clean without damage. On pavers, the method we use is pressure wash with a surface cleaner.

Method and pressure

Pressure wash with a surface cleanerCleaning method
Usually 1,500-3,000 PSI with a surface cleaner, adjusted to keep joint sand in place where possiblePressure

Cleaning solution: A paver cleaner or pre-treatment; efflorescence needs a dedicated cleaner.

Caring for pavers

Cleaning concrete and brick pavers removes weeds, moss and stains, but some joint sand washes out with them. Re-sanding the joints, often with polymeric sand, and sealing afterward keeps weeds and ants out and holds the pavers in place.

Avoid: A narrow tip aimed into the joints, which blows out sand and can loosen pavers.

How often: Clean every 1-2 years; reseal every 2-4 years.

When to book gum removal for pavers

  • Black dots across entrances and walkways
  • Gum on steps and near benches

What causes the dirt and stains

  • Foot traffic
  • Gum hardening and collecting dirt

Easy upkeep between cleanings

  • Scrape fresh gum before it gets ground in
  • Put bins near entrances

Not sure what you're looking at? The free stain identifier and safe pressure guide explain each stain and surface.

Common mistakes to avoid

  • Cold-water pressure alone smears gum and etches the concrete
  • Chemical removers that stain

What happens on the day

  1. Survey the area
  2. Soften gum with hot water or steam
  3. Remove it with a surface cleaner and detail tools
  4. Clean the surrounding area for an even look
  5. Schedule maintenance visits if needed

Gum Removal for Pavers cost in Hurst, TX

$200-$1,000Typical range depending on the area and how much gum there is
2-6 hoursTypical time on site
Every few months for busy entrancesRecommended frequency

What moves the price:

  • Area and number of buildings
  • Scheduling: early-morning, overnight or weekend work
  • Whether wash water has to be recovered under local stormwater rules
  • Frequency: recurring service is usually priced lower per visit

These are typical U.S. ranges, not a quote. You get an exact price before any work starts. For a quick estimate, try the pressure washing cost calculator.

Other services for pavers

Serving Hurst, TX and nearby towns

In Texas, commercial buildings and sidewalks often need cleaning several times a year, because mildew, gum and grime build up quickly in the heat.

Parts of Texas are exposed to hurricanes and tropical storms. After a storm, washing removes mud, debris and salt spray from siding, screens and walkways. Check for damage first: loose siding, broken screens and roof damage need repair before anyone washes them.

Near the coast, salt air leaves a film on siding, windows, screens and railings that dulls finishes and speeds up corrosion on metal. Regular rinsing and washing help protect them.

Some cities in Texas limit outdoor water use, including washing hard surfaces with a hose, especially during drought declarations. Pressure washers use far less water than an open garden hose, but rules vary, so it's worth checking your city's current restrictions. Wash water should also be kept out of storm drains.

We provide gum removal for pavers across Hurst (ZIP codes 76053 and 76054) and nearby towns including Bedford (2.1 mi), Richland Hills (3.4 mi), North Richland Hills (3.5 mi) and Colleyville (4.1 mi). Call (555) 010-0000 for a free quote in Hurst.

Gum Removal for Pavers: frequently asked questions

How much does gum removal for pavers cost in Hurst, TX?

Gum Removal for Pavers typically costs $200-$1,000 depending on the area and how much gum there is, and usually takes 2-6 hours. The exact price depends on the size and condition, and you get it before any work starts. Call (555) 010-0000 for a free quote.

Do you use high pressure for gum removal for pavers?

For pavers: usually 1,500-3,000 PSI with a surface cleaner, adjusted to keep joint sand in place where possible. What we avoid: a narrow tip aimed into the joints, which blows out sand and can loosen pavers. We keep the pressure even and controlled, with the right tools for the surface.

Is gum removal for pavers safe for my plants and pets?

We pre-wet plants and lawns, keep cleaning solutions diluted to what the surface needs, and rinse landscaping again when we finish. Keep pets and children inside until surfaces are rinsed and dry.

How often should I schedule gum removal for pavers?

Clean every 1-2 years; reseal every 2-4 years. Shade, nearby trees, humidity and heavy traffic mean more frequent cleaning; sunny, dry spots can go longer. Our free cleaning frequency tool gives a recommendation for your climate.

What if it rains on the day?

Light rain doesn't stop most washing, but heavy rain, high wind, lightning and freezing temperatures do. If the weather isn't right, we reschedule at no charge. Our work is backed by a satisfaction guarantee.

More services

Popular Exterior Cleaning Services in Hurst, TX

Deck Cleaning for Composite Decking

Low-pressure wash. Composite decking doesn't need staining, but it does grow mold and mildew, especially in shade and between boards.

Typical $250-$600

Rust Stain Removal for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $150-$500

Paver Cleaning & Sealing

Paver cleaning, re-sanding with polymeric sand and sealing to lock joints, deter weeds and bring back color.

Typical $600-$1,800

Graffiti Removal for Concrete

Pressure wash with a surface cleaner. Plain broom-finish concrete is the surface pressure washing is made for.

Typical $200-$800

Patio Cleaning for Flagstone

Low-to-moderate pressure wash. Flagstone covers several stones, including sandstone, slate, bluestone and limestone, and they react differently to pressure and chemicals.

Typical $150-$400

Stucco Cleaning

Stucco and EIFS soft washing that removes green and black growth, dirt and rust stains without damaging the finish.

Typical $300-$800

House Washing for Wood Siding

Soft wash. Painted and stained wood siding grows mildew and loses its finish faster on the shaded and weather-facing sides.

Typical $300-$700

Exterior Mold & Mildew Removal for Fiber Cement Siding

Soft wash. Fiber cement siding is durable and holds paint well, but its factory finish can be marked by high pressure, and manufacturers' care guides generally recommend low-pressure cleaning.

Typical $250-$700

Garage Floor Cleaning

Garage floor degreasing and pressure washing to lift oil, tire marks and road salt residue.

Typical $100-$300

HOA & Apartment Pressure Washing for Brick

Low-pressure wash. Brick is tough, but the mortar joints are softer than the brick itself, and older soft-fired brick can pit.

Typical $800-$5,000

Deck Cleaning for Pressure-Treated Wood

Low-pressure wash. Pressure-treated pine is the most common deck and fence wood.

Typical $250-$600

Pre-Paint Washing

Washing siding and trim before painting or staining so new paint bonds to a clean surface.

Typical $250-$600

Ready for a cleaner home or business?

Get a free pressure washing quote in Hurst, TX. Tell us what needs cleaning and we'll give you a price and the next available date.

Call NowFree Quote